Dehumidifiers Error Code Guide

Issue

• Dehumidifier Error Codes

Applies to

• Dehumidifier

Solution

AS, ES, F1, F2, L1, F5 - A temperature or humidity sensor has failed

• Please contact us for further assistance.
  

EC, F0 - Sealed system failure

• Please contact us for further assistance.

H3, E5 - Compressor Overload Protection

• Check installation for proper clearance. Check and clean filter if necessary. Operating temperature should be between 41F and 89F. Unplug unit and allow to cool.
• If you are unable to resolve your issued, please contact us for further assistance.

E4, C5 - Electronic Control Failure

• Please contact us for further assistance.

PU - Failure to pump out bucket in allotted time

• Make sure the pump drain hose is well connected.
• Check that the hose is not blocked, kinked or frozen.
• Remove and empty the water bucket to check the bucket pickup for blockage of dirt or algae.
• Turn off the unit and restart it under normal operating conditions.
• Unplug the unit and plug it in again under normal operating conditions.
• If you are unable to resolve your issued, please contact us for further assistance.

IF YOU WERE UNABLE TO RESOLVE YOUR ISSUE

• For units installed within the past 30 days, please refer back to your installer to resolve this issue.
• For units installed after 30 days please contact us to schedule service.