What do I do if water is leaking from the back of my Laundry Center?
Applies to
- Laundry Centers
Solution
Ensure that your inlet hoses are properly tightened and that they have rubber grommets installed to seal against the valve.
Ensure that you have both a cold and a hot inlet hose connected to the back of your Laundry Center.
Using only a cold (or only a hot) supply hose will result in water backflow through the valve and onto the floor.
If your machine appears to be properly installed, you may contact us for additional assistance by calling 1 (800) 374-4432 or visit our Contact Us page to send us a message.
Was this article helpful?
Related Articles
- Laundry Centers - How do I avoid Out-Of-Balance problems during the spin cycle?
- Why does my Frigidaire Laundry Center beep or have blinking lights?
- How to Clean and Care For Your Laundry Center
- Laundry Centers - How can I reduce the Wash cycle time?
- Laundry Centers - How do I pause or cancel a cycle?
- Laundry Centers - How long is the wash cycle on my Laundry Center?
- Laundry Centers - Can I use bleach with my Frigidaire Laundry Center?
- What should I do if the washer on my Laundry Center beeps twice and won't start?
- What should I do if my Frigidaire Laundry Center is not starting?
- Laundry Centers - The water level in my Frigidaire Laundry Center does not cover my laundry load. Is this normal?