What do I do if water is leaking from the back of my Laundry Center?
Applies to
- Laundry Centers
Solution
Ensure that your inlet hoses are properly tightened and that they have rubber grommets installed to seal against the valve.
Ensure that you have both a cold and a hot inlet hose connected to the back of your Laundry Center.
Using only a cold (or only a hot) supply hose will result in water backflow through the valve and onto the floor.
If your machine appears to be properly installed, you may contact us for additional assistance by calling 1 (800) 374-4432 or visit our Contact Us page to send us a message.
Was this article helpful?
Related Articles
- How to Clean and Care For Your Laundry Center
- Laundry Centers - How do I pause or cancel a cycle?
- Laundry Centers - After I press the start button, when will water fill the tub?
- Laundry Centers - How can I fill my Laundry Center Washer with water before adding my laundry and detergent?
- What should I do if my Frigidaire Laundry Center is not filling with water properly?
- Laundry Centers - What is Max Fill and how do I use it on my Frigidaire Laundry Center?
- Troubleshooting Your Laundry Center Washer Not Spinning
- Laundry Centers - How do I add Liquid Fabric Softener to my Laundry Center Washer?
- Laundry Centers - How long is the wash cycle on my Laundry Center?
- What should I do if the washer on my Laundry Center beeps twice and won't start?